Mercedes-Benz GLC, Operator'S Manual

Page: 347 / 390

Mercedes-AMG vehicles
All other vehicles
The brackets for the screw-in towing eye are
located in the bumpers. They are at the rear and
at the front, under covers : .
X
Remove the towing eye from the retainer
(
Y
page 333).
X
Mercedes-AMG vehicles: use a suitable
object, e.g. a screwdriver, to pry off cover :
on the front bumper from underneath. Take
the cover from the opening, but do not
remove it.
Press the mark on cover : on the rear
bumper inward and remove.
X
All other vehicles: press the mark on
cover : inward and remove.
X
Screw in the towing eye clockwise as far as it
will go and tighten it.
Vehicles with a trailer tow hitch do not have a
bracket for the screw-in towing eye at the back.
Connect the towbar to the trailer tow hitch
(
Y
page 216).
Removing the towing eye
X
Unscrew and remove the towing eye.
X
Attach cover : to the bumper and press until
it engages.
Towing a vehicle with both axles on
the ground
The automatic transmission automatically shifts
to position j when you open the driver's or
front-passenger door or when you remove the
SmartKey from the ignition lock. It is essential to
observe the following steps to ensure that the
automatic transmission remains in position i
during towing.
X
Make sure that the vehicle is stationary.
X
Turn the SmartKey to position 2 in the igni-
tion lock.
X
Depress and hold the brake pedal.
X
Shift the automatic transmission to position
i .
X
Leave the SmartKey in position 2 in the igni-
tion lock.
X
Release the brake pedal.
X
Release the electric parking brake.
X
Switch on the hazard warning lamps
(
Y
page 114).
In order to signal a change of direction when
towing the vehicle with the hazard warning
lamps switched on, use the combination switch
as usual. In this case, only the indicator lamps
for the direction of travel flash. After resetting
the combination switch, the hazard warning
lamp starts flashing again.
Towing and tow-starting
345
Breakdown
assistance
Z