Mercedes-Benz GLC, Operator'S Manual

Page: 122 / 390

X
Pull the defective bulb out of bulb holder E .
X
Insert the new bulb into bulb holder E .
X
Position trim D and engage it in place by
tapping it with your hand.
X
Check that all the metal clips are inserted in
the parts that were placed to one side: two
clips ; in the upper section of handle = and
four clips A in trim B .
X
If not, remove the missing metal clips from
the metal openings in the tailgate and insert
them in the appropriate places.
X
Grasp trim B and connect plug connector C
to the surround lighting.
i
The surround lighting only illuminates when
the tailgate has been shut and reopened.
X
Vehicles with EASY-PACK tailgate: insert the
plug connector for the switch at the top right
of the trim.
X
Vehicles with electric fold-out trailer tow
hitch: insert the plug connector for the switch
at the top left of the trim.
X
Position trim B and engage it in place by
tapping it with your hand, starting from the
outside.
X
Clip in the lower section of handle : again.
X
Insert and engage the upper section of handle
= into lower section : .
Windshield wipers
Switching the windshield wipers
on/off
!
Do not operate the windshield wipers when
the windshield is dry, as this could damage
the wiper blades. Moreover, dust that has col-
lected on the windshield can scratch the glass
if wiping takes place when the windshield is
dry.
If it is necessary to switch on the windshield
wipers in dry weather conditions, always use
washer fluid when operating the windshield
wipers.
!
If the windshield wipers leave smears on the
windshield after the vehicle has been washed
in an automatic car wash, wax or other resi-
dues may be the reason for this. Clean the
windshield using washer fluid after washing
the vehicle in an automatic car wash.
!
Intermittent wiping with rain sensor: due to
optical influences and the windshield becom-
ing dirty in dry weather conditions, the wind-
shield wipers may be activated inadvertently.
This could then damage the windshield wiper
blades or scratch the windshield.
For this reason, you should always switch off
the windshield wipers in dry weather.
1 $ Windshield wiper off
2 Ä Intermittent wipe, normal
3 Å Intermittent wipe, frequent
4 ° Continuous wipe, slow
5 ¯ Continuous wipe, fast
B í Single wipe
î Wipe with washer fluid
X
Switch on the ignition.
X
Turn the combination switch to the corre-
sponding position.
Vehicles with a rain sensor: in the Å or
Ä position, the appropriate wipe frequency
is automatically set according to the intensity of
the rain. In the Å position, the rain sensor is
more sensitive than in the Ä position, caus-
ing the windshield wiper to wipe more fre-
quently.
If the wiper blades are worn, the windshield will
no longer be wiped properly. This could prevent
you from observing the traffic conditions.
120
Windshield wipers
Lights
and
windshield
wipers