Mercedes-Benz EQS 350, Operator'S Manual

Page: 216 / 581

Combo 2 vehicle socket
1
Type 1 or type 2 connection for charging with
alternating current
2
Socket extension for charging with direct cur-
rent
%
When using a CCS (Combined Charging Sys-
tem) charging cable to charge with direct cur-
rent at a combo vehicle socket, both vehicle
socket connections
1
and
2
are used for
charging.
Charging options for the high-voltage battery
(mode 2, 3 or 4):
R
Charging through recuperation while the vehi-
cle is in motion
R
Charging with alternating current when sta-
tionary:
-
at a mains socket (mode 2)
-
at a wallbox or charging station (mode 3)
R
Charging with direct current when stationary:
-
at a rapid charging station (mode 4)
Depending on the country-specific vehicle equip-
ment and your vehicle's charging cable, single
phase AC charging is also possible.
Observe the different grid requirements of your
current location when charging. Only use charging
cables which conform to the grid requirements.
Consult a qualified electrician or your local grid
operator if you have any questions.
It is recommended that you charge the high-volt-
age battery at a wallbox or charging station due to
the improved charging performance and better
charging efficiency offered.
Stowing the charging cable
Always stow the vehicle charging cable in the
charging cable bag provided and attach its spring
hook to the tie-down eye in the boot or the load
compartment.
Otherwise, the charging cable is not sufficiently
secured.
System limits
The power output of the high-voltage battery may
be impaired by the following:
R
High or low outside temperatures
R
Electrical auxiliary consumers in the vehicle
being switched on, e.g. operating the air con-
ditioning system
R
Extended periods without charging
The charging time of the high-voltage battery may
be increased by the following:
R
High or low outside temperatures
R
Extended periods without charging
Driving and parking 213