Mercedes-Benz E 320 1994, Owner'S Manual

Page: 36 / 141

Storing seat/head restraint/
steering wheel positions in
memory:
D Memory button.
E Position buttons ” 1” and ” 2” .
Two sets of seat/head restraint/
steering wheel positions may be
programmed into memory. After
the seat/head restraint/steering
wheel are positioned, push me­
mory button D, release, and within
3 seconds push position button
” 1” . A second set of positions for
the same seat/head restraint/
steering wheel can be program­
med into memory by pushing first
button D and then ” 2 ” .
Recalling seat/head restraint/
steering wheel positions stored in
memory:
To recall a seat/head restraint/
steering wheel position, push
position button ” 1” or ” 2 ” until
seat/head restraint/steering wheel
movement has stopped. For safety
reasons, the seat/head restraint/
steering wheel movement stops
after releasing the position button.
Note:
See Index for instructions on
adjusting telescopic steering
column.
Caution!
Do not remove head restraints
except when mounting seat cov­
ers. For removal and installation
refer to Head Restraints, Removal
in Index. Whenever restraints have
been removed be sure to reinstall
them before driving.
Important!
Prior to operating the vehicle, the
driver should adjust the seat
height for proper vision as well as
fore/aft placement and seat back
angle to insure adequate control,
reach, operation, and comfort. The
head restraint should also be
adjusted for proper height.
Both the inside and outside rear
view mirrors should be adjusted
for adequate rearward vision.
Fasten seat belts. Infants and
small children should be seated in
a properly secured restraint
system that complies with U.S.
Federal Motor Vehicle Safety
Standard 213 and Canadian Motor
Vehicle Safety Standard 213.1.
All seat, head restraint, and rear
view mirror adjustments as well as
fastening of seat belts should be
done before the vehicle is put into
motion.
P 9 1 -0 0 4 2 B13
34