Mercedes-Benz E 320 1994, Owner'S Manual

Page: 55 / 141

Rear-Facing Bench Seat
The rear-facing bench seat can be
unfolded to enlarge the seating
area.
Warning!
Prior to occupying the rear-
facing bench seat, the rear
seat backrests must be in an
upright position and locked in
place. Hook the safety belts
into the brackets provided.
By pressing down on the
handle, lift the backrest into
place. Raise the seat cushion
in a similar manner.
Note:
If the rear-facing bench seat is to
be occupied, the forward-facing
split rear bench seat must be
equipped with head restraints.
To stow the rear-facing bench
seat, proceed in reverse order,
pulling the seat cushion up by its
strap.
Rear-Facing Seat Cushion -
Removal and Installation
By removing the rear-facing seat
cushion, if so equipped, an
additional cargo compartment is
available which can be locked with
the master key.
Removal: Press the two seat
latches (1) towards the center of
the car and pull the seat cushion
up a little and then back (2).
Installation: Place the seat cushion
on the floor of the cargo area and
push it forward (3) and down until
it locks in place.
53
O
p
e
ra
ti
o
n