Mercedes-Benz E 320 1994, Owner'S Manual

Page: 93 / 141

Checking Automatic
Transmission Fluid Level
Dipstick locking lever
1 Break seal
2 Release
3 Engage
Regular automatic transmission
fluid level checks are not required.
For this reason the dipstick open­
ing is sealed.
When noticing fluid loss or gear
shifting malfunctions, we recom­
mend to have your authorized
Mercedes-Benz dealer check the
transmission fluid level.
The transmission fluid level should
only be checked with the engine
idling, parking brake engaged and
selector lever in position ” P” . The
vehicle must be parked on level
ground.
Prior to the check, allow engine to
idle for approx. 1 to 2 minutes.
To pull dipstick from tube, break
seal by moving plastic pin (1)
sideways. Then open cap by
releasing locking lever (2).
Measure fluid level with the
dipstick completely inserted and
the locking lever released (2).
Extreme cleanliness must be
observed! To wipe the dipstick,
use a clean, lint-free cloth.
To fill the transmission with fluid,
pour it through a fine-mesh filter
into the dipstick opening. Even the
slightest impurity may cause
operational troubles.
The level of the transmission fluid
is dependent upon its temperature,
Two sets of maximum and mini­
mum fluid level marks on the dip­
stick are applicable references
only if the transmission fluid has
either reached its normal operat­
ing temperature of 176°F (80°C),
or its temperature is 86°F (30°C).
Important!
The fluid level must not exceed
the dipstick maximum mark. Drain
or siphon excess fluid, if required.
Then push dipstick all the way
in and swing locking lever
downward (3).
Note:
Damage to transmission caused
by contamination of transmission
fluid or overfilling of transmission
may result in serious transmission
damage which is not covered by
the Mercedes-Benz Limited
Warranty.
91