Telephone menu
Introduction
You can establish a Bluetooth
®
connection to
COMAND (
Y
page 179).
G
Warning
A driver's attention to the road must always
be his/her primary focus when driving. For
your safety and the safety of others, we
recommend that you pull over to a safe
location and stop before placing or taking a
telephone call. If you choose to use the
telephone while driving, please use the hands-
free device and only use the telephone when
weather, road and traffic conditions permit.
Some jurisdictions prohibit the driver from
using a mobile phone while driving a vehicle.
Bear in mind that at a speed of just 30 mph
(approximately 50 km/h ), your vehicle is
covering a distance of 44 feet (approximately
14 m) every second.
X
Switch on the mobile phone and COMAND
(
Y
page 123).
X
Press the
=
or
;
button on the
steering wheel to select the
Telephone
menu.
You will see one of the following display
messages in the multifunction display:
R
Phone ready
or the name of the network
provider: the mobile phone has found a
network and is ready to receive.
R
No Service
: no network is available.
Accepting a call
If someone calls you when you are in the
Telephone
menu, a display message appears
in the multifunction display, for example:
X
Press
6
on the steering wheel to accept
an incoming call.
If you are not in the
Telephone
menu, you can
still accept a call.
Rejecting or ending a call
X
Press the
~
button on the steering
wheel.
If you are not in the
Telephone
menu, you can
still reject or end a call.
Dialing a number from the phone book
You can use the mobile phone to enter new
telephone numbers into the phone book (see
COMAND) (
Y
page 187). If your mobile phone
is operational, you can select and dial a
number from the phone book at any time.
When you establish a connection to COMAND
via Bluetooth
®
, COMAND copies the phone
book from the mobile phone. This may take
some time.
While the on-board computer reads in the SIM
card:
R
you can dial a telephone number from the
redial list (
Calls Dialed
list).
R
you can dial a telephone number from the
telephone book stored in COMAND.
R
the multifunction display shows the
Reading data...
display message below
the phone book entries.
When the multifunction display shows the
Updating data...
display message,
COMAND has finished importing data. The
multifunction display then shows all the
phone book entries in COMAND and the
mobile phone.
338
Menus and submenus
On-board computer and displays
Summary of Contents for 2011 CL-Class
