User Manual FSK700-2 / FSK700-2SX
Chapter 3 • Installation
17
Check the detent and proper triggering of the micro switch by the locking cam.
Check if the label showing the key removal position, found on the inner door angle, conforms
with the installed locking half cylinder for the master key. An alternative label showing a hori-
zontal key removal position is included in the accessory kit of the Key Safe, see Fig. 8 below.
Fig. 8:
Label showing key removal position of the locking half cylinder designated for the master key
(key removal position on top)
On the left: factory default label
On the right: alternative label showing horizontal key removal position
3.5.3
Installation of additional locking half cylinders in Key Safe FSK700-2SX
Fire Brigade Key Safe FSK700-2SX is factory-equipped with two Locking Cylinder Mounting
Brackets. Using the supplementary Locking Cylinder Mounting Brackets PHZAW700-2S1, Key
Safe FSK700-2SX can be upgraded to up to four locking half cylinders.
A Locking Cylinder Mounting Bracket PHZAW700-2S1 is required for every additional locking
half cylinder.
Key Safe type FSK700-2 is not applicable for installation of additional locking half cylinders.
Installation is to be performed as follows:
Remove the inner door angle, see page 16 and onwards in chapter 3.5.1: "Removal of the inner
door angle".
Adjust the locking cam of the locking half cylinder so that it points downwards when assuming
the key removal position, see Fig. 7 above.
Insert the locking half cylinder into the Locking Cylinder Mounting Bracket and fix it in place
using the M5×12mm hex head screw included in the accessory kit.
Install the Locking Cylinder Mounting Bracket including locking half cylinder in the next avail-
able install position, see Fig. 9 below, left-hand picture. The required M4 nuts are included in
the accessory kit of the Locking Cylinder Mounting Bracket.
The cables leading from the Locking Cylinder Mounting Brackets should only be connected to
the Connection Board after all cables leading from the controlling and monitoring device have
been connected. See page 25 and onwards in chapter 4.5.3: "Connecting the cables of the Lock-
ing Cylinder Mounting Brackets".
HB_FSK700_1020_9161690_Englisch_D.odt / 1022 D / AN9161690
ZN62163/38/17
17
Summary of Contents for Fire Brigade Key FSK700 Series
Page 2: ......