16
Chapter 3 • Installation
User Manual FSK700-2 / FSK700-2SX
The locking bolt supplied in the accessory kit must only be installed in the outer door after
both the Fire Brigade Key Safe and the connected controlling and monitoring device are
fully operational! Should the electrical unlocking device not be fully operational upon clos-
ing the outer door with installed locking bolt, the Key Safe can only be opened again by
means leading to the destruction of some of its componentry (e.g., outer door, Drill Protec-
tion Board). Additional advice can be found on page 29 and onwards in chapter 5.4: "Com-
missioning instructions".
3.5.1
Removal of the inner door angle
For the tasks of installing the Fire Brigade Key Safe in the Flush Mounting Frame, setting up cable
connections, as well as for the installation of the locking cylinder(s) for the master key(s), the inner
door angle must be removed.
Removal of the inner door angle is to be performed as follows:
Open the outer and inner doors.
Remove all master keys.
Remove the 4 mounting screws on the inner door angle (see Fig. 6 below).
Pull out the inner door angle in a forward direction.
Fig. 6:
Location of the mounting screws for the inner door angle
The figure shows an already installed locking cylinder for the master key, as well as an inner
door including lock – these parts are not pre-installed in a newly shipped Key Safe!
Reinstallation of the inner door after completion of the planned tasks is to be performed with the
steps in reverse order.
3.5.2
Installation of a locking half cylinder in the Locking Cylinder Mounting Bracket
Depending on the case of application, either a locking half cylinder identical to the locking mech-
anisms used on-site, or alternatively, an auxiliary locking cylinder (see page 10 and onwards in
chapter 1.10: "Special terms") must be installed.
Locking cylinders that meet the requirements listed in the technical specifications on page 35 and
onwards in chapter 7.1: "Fire Brigade Key Safe FSK700-2, FSK700-2SX" are to be used exclus-
ively.
Remove the inner door angle, see page 16 and onwards in chapter 3.5.1: "Removal of the inner
door angle".
Adjust the locking cam of the locking half cylinder so that it points downwards when assuming
the key removal position, see Fig. 7 below.
Fig. 7:
Position of the locking cam with key removed
Insert the locking half cylinder into the Locking Cylinder Mounting Bracket and fix it in place
using the M5×12mm hex head screw included in the accessory kit.
HB_FSK700_1020_9161690_Englisch_D.odt / 1022 D / AN9161690
ZN62163/38/16
16
Summary of Contents for Fire Brigade Key FSK700 Series
Page 2: ......
