User Manual FSK700-2 / FSK700-2SX
Chapter 3 • Installation
19
Fix the position of the grub screw using the M5 nut included in the accessory kit.
For inner doors equipped with a locking half cylinder (ITA-2 and ITA-3), an M3×20 screw
must be used after installing the locking cylinder to limit the angle of rotation (see Fig. 10
above, right-hand picture, detail "C"), so the key cannot be removed when in unlocked position.
Afterwards, verify the proper functioning of the locking mechanism.
3.6
Installation of the Fire Brigade Key Safe in the Flush Mounting Frame
Connect the protective earth to the spot marked by the earthing symbol on Flush Mounting
Frame EZ700-2 or EZBS700-2.
Insert the cable lead-throughs included in the accessory kit of the Key Safe in the two desig-
nated openings in the back wall of the Key Safe.
Remove the inner door angle from the Key Safe (see page 16 and onwards in chapter 3.5.1:
"Removal of the inner door angle").
Insert the Key Safe into the Flush Mounting Frame, at the same time insert the cable leading
from the controlling and monitoring device through the upper cable lead-through, and – if avail-
able – insert the cable connecting the Drill Protection of Flush Mounting Frame EZBS700-2, as
well as the Tamper Switch of the Key Safe Column through the lower cable lead-through in the
back wall of the Key Safe.
Be careful that
- the cable(s) do not get crushed between the back wall of the Key Safe and the Flush Mounting
Frame, and
- the componentry inside the Key Safe does not get damaged during inserting the cables!
Fix the Key Safe in the Flush Mounting Frame using the M10 nuts, washers, and toothed lock
washers included in the accessory kit of the Flush Mounting Frame.
Tighten the nuts only as much so that the Key Safe is properly secured to the installation wall,
without deforming the base of the Flush Mounting Frame.
If the application of the Weather Protection Hood is indicated by weather conditions, the
Weather Protection Hood must be installed before fixing the Key Safe to the wall. Insert the
Weather Protection Hood from above, between the wall, or Key Safe Column, respectively, and
the door frame of the Key Safe, and fix it using M10 nuts. Be careful not to damage the cellular
rubber strips attached to the back sides of the Weather Protection Hood and the door frame.
Fig. 11:
Fixing the Key Safe (example: FSK700-2SX, able to keep four master keys) into the Flush
Mounting Frame
Detail "A": Nuts for fixing the Locking Cylinder Mounting Bracket in Key Safe FSK700-2, or the
L-bracket with Locking Cylinder Mounting Brackets in Key Safe FSK700-2SX, respectively. See
page 22 and onwards in chapter 4.4: "Connecting".
HB_FSK700_1020_9161690_Englisch_D.odt / 1022 D / AN9161690
ZN62163/38/19
19
Summary of Contents for Fire Brigade Key FSK700 Series
Page 2: ......