User Manual FSK700-2 / FSK700-2SX
Chapter 3 • Installation
15
3.3
Installation of Flush Mounting Frame EZ700-2 or Flush Mounting Frame with
Drill Protection EZBS700-2
1)
The front edge of the Flush Mounting Frame must not protrude from the wall
Fig. 5:
Dimensions of Flush Mounting Frames EZ700-2 and EZBS700-2
The front edge of the Flush Mounting Frame must be flush-mounted to the wall surface (under no
circumstances must it protrude!) as best as possible. The bottom edge of the Key Safe should be
located about 1.2m (at least 0.8m) above the floor.
Installation of Flush Mounting Frames EZ700-2 and EZBS700-2 is to be performed according to
the manual provided with the Flush Mounting Frames.
Insert the Flush Mounting Frame into the prepared opening in the wall, and insert the conduits
for the connection cables, as well as for the protective earth into the Flush Mounting Frame
from behind.
Notice the required installation position (labelled: "OBEN / TOP SIDE – Einbauzarge
putzbündig einmauern!").
Fix the Flush Mounting Frame onto the installation surface.
Fill the remaining openings in the Flush Mounting Frame, as well as the inner space with suit-
able materials, to prevent mortar, cement, or similar from entering while setting the Flush
Mounting Frame into the wall.
Protect the drill protection film inlaid in the Flush Mounting Frame with Drill Protection EZB-
S700-2, and the connection cable from damage while setting the Flush Mounting Frame into the
wall.
Fix the Flush Mounting Frame in the wall.
3.4
Installation of Flush Mounting Frame EZ700-2 or Flush Mounting Frame with
Drill Protection EZBS700-2 in Key Safe Column SDS700-2
Instructions for installation in the Key Safe Column SDS700-2, with or without cement grouting
according to VdS guidelines 2105 and 2350, are found in the manual "Key Safe Column
SDS700-2" by MEP-Gefahrenmeldetechnik GmbH.
3.5
Preparation of the Fire Brigade Key Safe
The Series FSK700 Fire Brigade Key Safe must be fitted with the appropriate inner door, as well as
the locking cylinder(s) for the master key(s) or auxiliary locking cylinder(s). Installation of addi-
tional Locking Cylinder Mounting Brackets PHZAW700-2S1 along with appropriate locking cylin-
ders is required for the Series FSK700-2SX Key Safe if more than two master keys are to be kept.
It is possible to perform the following tasks on an already installed Key Safe – however, it is
recommended to complete preparation of the Key Safe before installation in the Flush Mounting
Frame.
HB_FSK700_1020_9161690_Englisch_D.odt / 1022 D / AN9161690
ZN62163/38/15
15
Summary of Contents for Fire Brigade Key FSK700 Series
Page 2: ......