Unsetting the system
The unsetting of the alarm system can be performed at any remote keypad.
SYSTEM OPEN
17:30
01 JAN
Enter Your Code
Time left > 0015
? ? ? ?
1
2
? ? ? ?
? ? ? ?
OPEN
0015
1
2
1
2
LCD Remote
Starburst Remote
LED Remote
1.
Enter the premises via the prescribed entry route and proceed directly to the remote
keypad. The internal sounders generate an interrupted tone. The display will show the
remaining entry time.
2.
Enter your 4 digit passcode before the entry timer expires. The internal sounders will
stop and the display will show “SYSTEM OPEN”. After 5 seconds the “SYSTEM OPEN”
message will disappear and the display will show the time, (date and banner text,
LCD only).
�
If the entry time is exceeded an alarm is generated from the internal
sounders and the “Second Entry” timer is started. If at the end of the “Second
Entry” timer the alarm system has not been unset a full alarm condition will
occur. If the alarm company has set the “Second Entry” timer to zero the full
NOTES
alarm will occur when the first entry timer expires.
�
If during the entry procedure the user strays from the prescribed entry route
and activates a detection circuit a full alarm will occur (internal sounders
and external sounders). If the alarm system is fitted with a remote signalling
device this will also be triggered.
�
The alarm system can be programmed with an “Abort” feature which will
allow the system to transmit an abort signal to your alarm receiving centre.
On receiving this signal your alarm receiving centre will cancel any police
action. This feature is controlled by time delay (normally set to 90 seconds).
Following a full alarm condition you must enter your passcode with this time
period in order to send the abort signal, if you fail to enter your passcode
before the timer expires police action will be taken.
8
