Memmert HCP 108, Operating Instructions Manual

Page: 13 / 48

HCP page 13
4.3 Switching on 4.3 Switching on
The oven is switched on by pressing the push/turn control.
Oven switched off. The push/turn control is
pushed in and protected against damage. Oven switched on and can be operated using
the push/turn control and the SET key.
4.4 Setting the temperature (quick setting) 4.4 Setting the temperature (quick setting)
Hold down the SET key and set the temperature setpoint with the push/turn control.
After the SET key has been released the display briefly flashes the temperature setpoint. The display then
changes to the actual current temperature and the controller starts to control to the selected temperature
setpoint.
5 Selecting the operating mode 5 Selecting the operating mode
After holding down the SET key (approx. 3 sec), the current operating mode flashes on the display. A
different operating mode can be selected with the push/turn control while the SET key is being held down.
After the SET key has been released the controller operates in the new operating mode.
PRINT
SETUP
Normal
operation
Weekly
programmer
Programme
operation
Printer Basic
settings
6 Setting the parameters 6 Setting the parameters
After an operating mode has been selected, all relevant controller settings are shown simultaneously on
the display.
A parameter (menu item) can be selected by rotating the push/turn control; all other parameters are then
dimmed.v
The selected parameter flashes brightly and can now be altered with the push/turn control while holding
down the SET key.
After the SET key has been released the newly set value is stored.
If the push/turn control or the SET key have not been operated for a period of 30 seconds, the controller
automatically returns to the main menu.
Interior lighting (option) Interior lighting (option)
Turn the push/turn control anticlockwise until the light symbol
While holding down the SET key, use the push/turn control to set the light
on
or
off
.
When operating in the “weekly programmer” mode the internal illumination is switched off automatically
when the equipment is switched off by the weekly programmer.
loop
t1
t2
t3
t4
loop
t1
t2
t3
t4