Meiko M-iClean H series, Operating Instructions Manual

Page: 54 / 62

9750359 54 / 62
Maintenance work
Visual inspection
U= M
-iClea
n U
H=M
-i
Clean
H
Chec
ked
Clean
ed
Repla
ced
Maintenance
requirement
7. Wastewater installation
Replace flap on ventilation valve U/H annually
Check operation of drain pump during drainage U/H annually
Check pumps, hoses and wastewater heat exchangers (optional
extra) are not leaking
U/H annually
8. Detergent dosing
Replace peristaltic hose and seals on the nozzles U/H annually
Check detergent dosing system is working and not leaking U/H annually
9. Rinse aid dosing
Replace peristaltic hose and seals on the nozzles U/H annually
Check rinse aid dosing system is working and not leaking U/H annually
10.Test run including functional test of whole machine
Check filling and heating until it is ready for operation U/H annually
Visual inspection of the entire machine for leaks U/H annually
Check results of test wash and rinse U/H annually
11. Options
Integrated reverse osmosis system (if applicable)
Visually check whole system for leaks U/H annually
Change pre-filter (standard membrane (<0.1 mg/l)) U/H every 6 months
Change pre-filter (chlorine-resistant
membrane (≥ 0.1 and ≤ 2.0 mg/l))
U/H every 3 months
Check fine sieve insert and choke in concentrate pipeline U/H annually
Check correct function of concentrate drain and check for deposits U/H annually
Fill in separate log, "Certificate of Commissioning, GiO" U/H annually
Partial demineralisation (PD)/Full demineralisation (FD) (if applicable)
Functional test U/H annually
Heat retention system (if applicable)
Visually check lever arm H annually
Check sheeting for damage H annually
Functional test H annually
Exhaust air heat recovery (if applicable)
Functional test of fan U/H annually
Functional test of solenoid valve U/H annually
Carry out visual inspection and leak test U/H annually
12. Water quality, temperature
Drinking water °C °dH °CH µS/cm U/H annually
Water quality after water
treatment (if applicable)
°C °dH µS/cm U/H annually
13. Electrical safety check (certificate is optional)
Carry out the visual inspection U/H annually
Check the protective earth conductor U/H annually
Insulation resistance measurement U/H annually
Measure current on protective earth conductor U/H annually