Medoc TSA 2001, Technical Reference Manual

Page: 80 / 188

Q-Sense Technical Reference Manual
Proprietary 80 of 188
7.7 Standard Events
Standard Events are pre-defined events that occur during the test such as the onset of a stimulus
or reaching the destination temperature. Events are marked by a sound.
Every event is also marked on the screen during the test by an asterisk (*).
7.7.1 Standard Event Configuration
To configure standard events in the required program, follow the steps detailed below:
1. From the Programs screen, select the program you want to configure standard events for and
double click to open the program editor or click on the edit program button
2. From the list of parameters, select the Standard Events option
Figure 44: Standard Events in Program Editor
3. Click the arrow on the left to open the standard event editor.
For each event that you want to configure mark the Sound column to activate.
4. Click anywhere on the screen to close the Standard Events dialog.
5. The available standard events vary according to the test method. For a list of the available
standard events according to the program type continue to the following section.
7.7.2 List of Standard Events according to Program Type
The available standard events according to program type are detailed in the table below:
Table 22: List of standard events according to program type
Program
Method Standard Events Description
Limits Onset The start of each trial in the sequence
Levels Onset The start of each trial in the sequence
TSL Destination Subject response was detected
Ramp and Hold
(optional)
Onset
The start of each trial in the sequence
Note: In current release that is the only Standard
Event available for Ramp and Hold.
Destination
Thermode temperature reached target temperature
Note: Will be available in next release
End of duration
End of duration at target temperature
Note: Will be available in next release