mecalac AS 150e, Maintenance Manual

Page: 5 / 19

S160/S161/S165/Z162 8-5
Maintenance 8
1
2
3
4
8.2.2.3 Front axle
(1) Unscrew the plugs from the axle arch (8-4/arrow) or
(8-5/arrow).
N O T E
- The oil level must reach the plug bore.
If necessary, top up oil.
- Collect any oil that escapes.
(2) Screw in the plug again.
8.2.3 Oil level check (distribution
gear)
8.2.3.1 Oil level check (distribution gear)
Type 1:
(1) Remove the foot mat in the footwell of the operator’s
cabin.
(2) Dismantle the floor plate under the foot mat.
(3) Check the oil level using the check marking of the oil
dipstick(8-6/1) for the upper oil compartment (coupling
space).
(4) Unscrew the plug (8-6/4) from the lower oil compart-
ment (spur gear space).
NOTE
- The loader must have been standing still for
at least 15 minutes before you can check the
oil level.
- The transmission housing temperature must
be at least 60 °C (warm up if necessary).
- The oil level must reach the plug bore (8-6/4).
- If necessary, fill oil into oil filling screw 8-6/2
(upper oil compartment) or 8-6/3 (lower oil
compartment) until the oil reaches the required
level.
The filling bore of the upper oil compartment is
accessible when you have loosened the union
nut of the ventilation hose and pushed the hose
aside.
- Collect any oil that escapes.
(5) Fit a new gasket and screw the plug back in.
Figure 8-4
Figure 8-6
Figure 8-5
Top view Front view