Page 17
Installation
optoNCDT ILR 1181 / 1182
Reflector
Reflector
Reflector
Fig. 5 Sensor orientation at reflector film
5.3
Electrical Connections
Located on the back cover is a connector terminal. A 12-pole round-type (flangemount) series 723 connector
from Binder has been selected for this purpose. It is sealed against the casing to comply with IP 65 require-
ments.
This connector type guarantees optimized screening and a high IP degree. The required counterpart is an
adequate female cable connector with grading ring, available as an optional accessory.
The PC11x cable set with open ends is optionally available.
Bending radius of the supply and output cable PC11x (available as an optional accessory):
- 47 mm (once)
- 116 mm (permanent)
Avoid exposed cable
ends.
So you prevent any
kind of shorts.
The wiring of outputs
with input signals
can damage the
sensor!
