Technical Manual Glass Push Button II Smart BE-GT2xx.01
MDT technologies GmbH •
51766 Engelskirchen • Papiermühle 1
Tel.: +49-2263-
880 •
Fax: +49-2263-4588
• [email protected] • www.mdt.de
77
Switching type
Limit stop
Overrun
Only available with two-
button function!
Setting what should happen
when the last switching value is
reached
Switchover considers status
object
x
Yes
x
No
Setting whether the
changeover should send the
next switching value according
to the current status
Table 60: Settings - Mode selection
Function principle:
The function "mode selection" can send up to 4 different operating modes by shortly pressing a
button. The operating modes are switched one after the other. Depending on the set parameters, for
example, at a keystroke the second operating mode is sent if the 1st operating mode has been sent
before or the third operating mode will be sent if the second operating mode has been sent before
…
Parameter Long
push utton
:
In addition to switchover by a short keystroke, a fixed operating mode can be sent at a long
keystroke.
Here one of the 4 operating modes can be sent. This means that a fixed operating mode
(independent of the last switching value) would always be sent with a long keystroke.
Parameter
“ it hing type
:
Limit stop:
With the switching type "Limit stop" the 4th operating mode is sent again after sending
the 4th operating mode.
Overrun:
In the switching type "Overrun", the 1st operating mode is sent again after the 4th
operating mode.
For the single-button function, this parameter is set permanently to "Overrun".
