Me2, Fog Generator
Operating Guide, Rev: A/a
18 / 30
B
OOTLOADER
The MDG
Me2
uses a BootLoader, also called boot manager. This program is a firmware
(software embedded in a hardware device) located into the non-volatile memory of the
microcontroller unit (MCU) that allows in-circuit reprogramming of the device using its USB
communication port.
To upgrade the firmware, you will need:
a computer running under Windows, with a USB 2.0 connector
special driver for the USB, included in the package,
a standard USB 2.0 cable, A to B Male/Male type
Contact the MDG Service to have the last package firmware upgrade for the MDG
Me2
.
RDM
C
ONTROL
The MDG
Me2
can be controlled via a RDM ANSI E1.20 protocol, an intelligent bi-directional
communication utilizing the DMX512 data link.
RDM allows a console or other controlling device to discover and then configure, monitor, and
manage intermediate and end-devices connected through a DMX512 network. RDM provides for
intelligent control of devices on a DMX512 network, which has not been previously available
outside of proprietary networks
RDM Control has the same functionalities than the DMX Control (
see DMX Control
) with bi-
directional functions allowing the user to read or write specific functions.
Summary of Contents for ME2
