11
14-MENU ITEMS AND OPERATION
Technical Dept. - All rights reserved - Reproduction prohibited
h - Pellet Recipe
This function is for adapting the stove to the type of pellet in use. As there are many types of pellets available on the market, operation
of the stove can vary considerably according to the quality of the fuel. When the pellets clog up the brazier due to excess loading of fuel
or when the flame is always high even at low power, or when the flame is low, it is possible to decrease/increase the amount of pellets
in the brazier:
The available values are:
-3 = A decrease of 20% with respect to the factory setting.
-2 = A decrease of 13% with respect to the factory setting.
-1 = A decrease of 6% with respect to the factory setting.
0% No changes.
3 = An increase of 10% with respect to the factory setting.
2 = An increase of 6% with respect to the factory setting.
1 = An increase of 3% with respect to the factory setting.
Proceed as follows to edit the recipe:
• Press the “menu” key.
• Use the arrow keys to scroll through and select “Settings”
• Press “menu” to confirm.
• Scroll with the arrows and select “Pellet recipe’’
• Press “menu” to confirm.
• Edit the % by using the + - keys.
• Press ‘’menu’’ to confirm and ‘’esc’’ to exit.
i - Smoke rpm % variation
In the event the installation presents problems in extracting smoke (lack of draught or even pressure in the duct), it is possible to increase
the smoke and ash extraction speed. This change resolves all potential problems related to pellets clogged in the brazier and deposits
forming at the bottom of the brazier itself caused by poor quality fuel or fuel that produces a lot of ash. The values available range from
-30% to +50%, with increments of 10 percent at a time. Negative variation may be required if the flame is too low.
To edit this parameter, proceed as follows:
• Press the “menu” key.
• Use the arrow keys to scroll through and select “Settings”
• Press “menu” to confirm.
• Scroll with the arrows and select “Fume rpm Var.”
• Press “menu” to confirm.
• Edit the % by using the + - keys.
• Press ‘’menu’’ to confirm and ‘’esc’’ to exit.
j - Components test
This can only be done when the stove is off and allows you to select the components to be tested:
• Glow plug
: it is turned on for a fixed period of 1 minute during which the panel displays the countdown in seconds.
• Feed screw
: it is powered for a fixed period of 1 minute during which the panel displays the countdown in seconds.
• Extractor
: it is activated at 2500 rpm for a fixed period of 1 minute during which the panel displays the countdown in seconds.
• Heat exchanger
: enables you to conduct the test in V5 for a fixed period of 1 minute during which the panel displays the countdown
in seconds.
Proceed as follows to enable the “Components test” function (only with stove off):
• Press the “menu” key.
• Use the arrow keys to scroll through and select “Settings”
• Press “menu” to confirm.
