570S-GT4_Technical-Manual_Mar-20_v7
111
Figure 111: Locknut, level pin, turnbuckle location
NOTE: Do not rotate the actuator rod within the capsule, as this can cause damage to the part.
Support the rod to prevent it from rotating when adjusting the turnbuckle.
Step 9
9.
Reassemble and torque the locknut to 5.4Nm. Repeat steps 7, 8 & 9 until P1 preload is set
correctly
10.
Once the wastegate preload has been set correctly, disconnect the Mityvac and refit the
vacuum line
a.
NOTE: Take care when refitting the wastegate line to ensure no kinks are present
11.
Refit the rear LH airjack, heatshields and floors.
Summary of Contents for 570SGT4
Page 1: ...TECHNICAL MANUAL...
