MC3 ChipMaster, Operation & Maintenance Manual, Page: 19 / 63

ChipMaster Conveyor
Operation & Maintenance Manual
19
Rev. 05-2021
Starting the First Time
Make sure area is clear of people and foreign objects.
Note: Before starting the conveyor for the first time, ensure there are no foreign objects (nuts,
bolts, tools etc.) on the frame or belt. The area around the conveyor should be cleared of personnel
and ‘Caution’ tape or temporary fencing should be installed to prevent access to any moving parts.
 To start the conveyor, press the <Start> button on the control panel or issue the start
command from your machine control system.

If the motor starts but the torque limiter slips, immediately stop the conveyor and lockout
the electrical system. Check the torque limiter for contamination with oil or grease. If it is
clean then it will have to be adjusted. Please refer to the safety considerations regarding
the torque limiter on Page 9 of this manual and the manufacturers information sheet in the
Appendix.
Note : Do not over-tighten the torque limiter. This will lead to premature failure or over-loading of
the drive motor. The torque limiter needs to be adjusted so that it will carry no more than the
weight of the belt and the required load.
 After cleaning or adjusting the torque limiter, re-start the conveyor and ensure that the
conveyor operates correctly.

Run the conveyor for approximately 30 minutes to allow the components to ‘settle in’. Stop
the conveyor and
lockout the electrical system.

Check the tension on the belt and the drive chain and adjust if necessary. Re-check the
tightness of all nuts, bolts and set screws.

After the initial run and all adjustments have been made, install the covers on the tail end,
incline, and motor drive.

Replace the two chain guards located under the discharge area.