■
Installation instructions (For Mazda CX-7 only)
：
CX-7
−
5
WIRING <Installation of iPod integration module>
Pad protector
(Cut into 50x15 mm and affix)
Double-sided adhesive
tape (Cut and affix)
Pad protector
iPod integration
module
Vehicle
front
Tie wrap (small)
○
A
Pad protector
(Cut into 50x50 mm and affix)
Tie redundant part
Tie wrap (large)
Pad protector
Pad protector
Vehicle
front
Harness (c) (To audio unit)
(Route harness so that
this part is approx. 250 mm)
250mm
Cut 20x30 mm
Glove compartment (backside)
[Glove compartment cutting]
Top
2. INSTALLATION AND WIRING
z
To prevent an open or short circuit in the wiring of the iPod integration module, be sure to route cables
avoiding sharp edges and burrs on the vehicle's sheet metal.
z
To ensure proper adhesion, be sure to degrease the area where the double-sided adhesive tape is to
be adhered.
z
After fixing a cable with a tie wrap, cut off excess tie wrap using nippers. Otherwise it may interfere with
other parts causing malfunction or noise.
CAUTION
Put iPod connection cable in glove compartment
(Cable 30 cm from instrument panel)
Vehicle
front
Vehicle front
iPod connection cable
Tie wrap (small)
○
A
Remove connector cover when connecting iPod;
fit connector cover when iPod is not used
iPod connection cable
iPod integration module
Harness (c)
(To audio unit)
Tie redundant part
(Tie up using 2 straps (large)
and secure to heater duct with
pad protectors in two locations)