49
AFTER ANY SENSOR REPAIRS OR CHANGES:
DOCK THE ANCHOR AND RESET THE SENSOR. SEE PAGE 37.
OTHER TROUBLESHOOTING
POSSIBLE CAUSE/ACTION
$XWR$QFKRUFRXQWVZKHQWKHZLQGODVVLV
not turning or counts erratically displaying a
large number. The screen may display
Sensor
unstable
and the unit may beep when turned off
or locked.
8QFRQWUROOHGDQFKRUURGHFRXOGEHUXQQLQJ
through the windlass or there may be some
external interference.
7KHVHQVRUPD\EHGDPDJHG7KHVHQVRU
FDEOHLVQRWWKHVSHFL¿HGW\SHRUWKHFRQQHFWLRQ
may be faulty.
&KHFNWKHVHQVRUZLULQJ,IWKH$$VHQVRU
plug is not used the wires must be soldered. All
wires must be connected (including the drain)
and shielded cable must be used.
$XWR$QFKRUFRXQWVEXWGRHVQRWRSHUDWHWKH
windlass
Total length of rode has been set to off.
AutoAnchor then operates as a counter only.
6HHSDJH
7KHFRXQWSDXVHVGXULQJUHWULHYDO
This applies to rope/chain rode only.
If the sensor indicator (arrow) is still pulsing, this
is not a fault. The rode is changing from rope
to chain.
7KHFRXQWVWD\VRQ]HURZKHQURGHLV
deployed and counts out when rode is retrieved.
The unit is not receiving correct direction
LQIRUPDWLRQ6ROHQRLGXSDQGGRZQZLUHVDUH
swapped.
:LQGODVVGHSOR\VZKHQWKH8SEXWWRQLV
SUHVVHGDQGUHWULHYHVZKHQWKH'RZQEXWWRQLV
pressed.
7KHPRWRURUVROHQRLGZLULQJLVUHYHUVHG
Change the wiring and check the direction of
windlass rotation. If the brown and white wires
are connected, also check that they are correct
after you have changed the wiring.
%XWWRQVDUHVZDSSHGLQWKHZLQGODVVPHQX
6HHSDJH
:LQGODVVGRHVQRWVWRSH[DFWO\DWWKHSUHVHW
point.
6WRSSLQJLVDFFXUDWHWRFKDLQZKHHO
revolution. The chainwheel will run on slightly
with momentum.
:LQGODVVVWRSVEHIRUHWKHOHQJWKRIURGH
VSHFL¿HGLVGHSOR\HG
Using the Automatic function the rode release
VWRSVIWPVKRUWRIWKH7RWDO/HQJWKRI5RGH
RQ%RDUGVHWWLQJ
FOR ADDITIONAL TROUBLESHOOTING:
Contact AutoAnchor support
RQ
ZZZDXWRDQFKRUFRQ]DXWRDQFKRULQVWDOODWLRQKHOSSKS)LOOLQWKHLQIRUPDWLRQIRUP
(PDLOVXSSRUW#DXWRDQFKRUFRQ]RU7HOHSKRQH
