DS33Z41 Quad IMUX Ethernet Mapper
112 of 167
9.6 Ethernet Interface Registers
The Ethernet Interface registers are used to configure RMII/MII bus operation and establish the MAC parameters
as required by the user. The MAC Registers cannot be addressed directly from the Processor port. The registers
below are used to
perform indirect read or write operations to the MAC registers. The MAC Status Registers are
shown in
Table 9-7
. Accessing the MAC Registers is described in the Section
8.14
.
9.6.1 Ethernet Interface Register Bit Descriptions
Register Name:
SU.MACRADL
Register Description:
MAC Read Address Low Register
Register Address:
140h
Bit
# 7 6 5 4 3 2 1 0
Name MACRA7 MACRA6
MACRA5 MACRA4 MACRA3 MACRA2
MACRA1 MACRA0
Default
0 0 0 0 0 0 0 0
Bits 7 to 0: MAC Read Address (MACRA7 to MACRA0).
Low byte of the MAC address. Used only for read
operations.
Register Name:
SU.MACRADH
Register Description:
MAC Read Address High Register
Register Address:
141h
Bit
# 7 6 5 4 3 2 1 0
Name
MACRA15
MACRA14
MACRA13
MACRA12
MACRA11
MACRA10
MACRA9
MACRA8
Default
0 0 0 0 0 0 0 0
Bits 7 to 0: MAC Read Address (MACRA15 to MACRA8).
High byte of the MAC address. Used only for read
operations.
Register Name:
SU.MACRD0
Register Description:
MAC Read Data Byte 0
Register Address:
142h
Bit
# 7 6 5 4 3 2 1 0
Name MACRD7 MACRD6 MACRD5 MACRD4 MACRD3 MACRD2 MACRD1 MACRD0
Default
0 0 0 0 0 0 0 0
Bits 7 to 0: MAC Read Data Byte 0 (MACRD7 to MACRD0).
One of four bytes of data read from the MAC. Valid
after a read command has been issued and the
SU.MACRWC
.MCS bit is zero.