Matrix SETU VFXTH System Manual
130
The valid range of the VoIP Silence Disconnect Timer is 001 to 999 seconds. Default: 999 seconds.
•
Routing Group Busy Wait Timer:
It is the duration for which SETU VFXTH searches for a free
destination port in the Routing Group and the Fallback Routing Group to route and place the call. The
Routing Group Busy Wait Timer is loaded when no destination port is free in both the Routing Group
and the Fallback Routing Group.
The valid range of the Routing Group Busy Wait Timer is 1 to 99 seconds. Default: 1 second.
•
Transfer Notification Timer (Seconds):
It is the duration for which SETU VFXTH will wait for
notification of the status of a transferred call, whether transfer target is busy, has answered, has
disconnected, etc.
This timer is loaded as soon as a user performs a transfer activity and the user (transferor) is notified of
the status of the transfer activity within this timer.
The valid range of the Transfer Notification Timer is 1 to 999 seconds. Default: 60 seconds.
•
Ring Timer (Seconds):
It is the duration for which SETU VFXTH will play a ring on the FXS Port to
indicate an incoming call. The Ring timer is loaded when the call is placed on the FXS Port, that is,
either there is a ring event on the FXS Port or call waiting beeps in case the FXS Port is busy.
The valid range of the Ring Timer is 1 to 99 seconds. Default: 45 seconds.
•
DTMF Detection on FXS Port:
Select an appropriate method to detect DTMF digits on the FXS Port.
SETU VFXTH can detect the DTMF digits either using SLIC Module or using DSP. Default: Using SLIC
Module.
•
Error Tone Timer:
The time for which the system plays the Error Tone. The valid range of the Error
Tone Timer is 0 to 9. Default: 7 seconds.
•
Error Tone Delay Timer:
It is the duration after which the system will play the Error Tone, if the call is
disconnected during speech. The valid range of the Error Tone Delay Timer is 00 to 99 seconds.
Default: 00 seconds.
•
Remove Country Code from CLI received:
You may remove country code from the CLI received on
the source port, before presenting it on the destination port, if required.
If you want the system to remove country code from the CLI received, select this check box. Default:
Disabled. Make sure you configure
under
Region
in Basic Settings.
