49
8.18 swing ArM rePlAceMent
1) Remove the black plastic cover on the lower swing arm joint (Figure A).
2) Remove the bolt that holds the swing arm to the pedal and link arms (Figure B).
3) Carefully tap the crank arm inward until it can be pulled free of the bearing housing (Figure C & D).
4) Loosen one of the bolts on either side of the upper pivot joint (Figure E).
5) Holding onto the swing arm, push / pull the pivot shaft out of the bearing housing (Figures F and G).
6) Transfer the rubber arm pad and plastic parts to the new swing arm. (Figure H).
7) Reverse Steps 1-6 to install the new swing arm. NOTE: Be aware of the spacer between the bearings that the shaft passes through (Figure I).
8) Test the Ascent Trainer for function as outlined in Section 8.20.
cHAPter 8: PArt rePlAceMent gUide
figUre A
figUre b
figUre c
Summary of Contents for A3x-01 Ascent Trainer
