44
1) Remove the plastic cover where the dual action handlebar meets the pedal arm (Figure A).
2) Remove the bolt and bushings where the dual action handlebar and the pedal arm meet (Figure B).
3) Remove the two bolts holding the dual action handlebar to the console mast pivot (Figure C).
4) Remove the pivot cap and handlebar (Figure D).
5) Reverse steps 1-4 to install a new dual action handlebar.
6) Test the Ascent Trainer for function as outlined in Section 8.20.
figUre A
figUre b
figUre c
figUre d
cHAPter 8: PArt rePlAceMent gUide
8.14 dUAl Action HAndlebAr rePlAceMent
Summary of Contents for A3x-01 Ascent Trainer
