Page 21
(2) SQUARING THE BLADE TO
THE TABLE
WARNING Failure to unplug your
saw could result in accidental starting
causing serious injury.
NOTE: To do accuracy adjustment,
you will need the combination square
(not supplied).
NOTE: To correct angle accuracy of
the blade to the miter table, either by
squaring the blade to the table, or by
adjusting the blade to the miter table
45° bevel, 0° miter. You can get the
same results.
Step 1: Unplug the saw.
Step 2: Set the bevel & miter angles to 0°.
Step 3: Lower and lock the saw arm in the
“Down” position.
Step 4: Set the Miter angle at 0° and lock it
in place.
Step 5: Place a combination square on the
miter table with the rule against the table
and the heel of the square against the
body (not teeth) of saw blade.
Step 6: If the blade is not 90° to the Miter
table, loosen the bevel-lock lever.
Step 7: Loosen the locking blots which are
located on the back of the saw (Fig. 22)
with small hex key (not supplied) and
carefully tilt the saw arm left or right until
the heel of the square is flush with the saw
blade along its entire length.
Step 8: Once the angle is set, retighten all
of the bolts and the bevel-lock lever.
(3) ADJUSTING THE BLADE TO
THE MITER TABLE 45°BEVEL,
0° MITER
WARNING Failure to unplug your
saw could result in accidental starting
causing serious injury.
NOTE: To do accuracy adjustment,
you will need the combination square
(not supplied)
and remove the rule of
the combination square. Due to tight
checking place, only use the
combination Square’s head.
NOTE: To correct angle accuracy of
the blade to the miter table, either by
squaring the blade to the table, or by
adjusting the blade to the miter table
45° bevel, 0° miter. You can get the
same results.
Step 1: Unplug the saw.
Step 2: Set the bevel-angle to 45° and lock
it in place.
Step 3: Lower the saw arm and push the
locking pin to lock the saw arm in the
“Down” position.
Step 4: Set the miter-angle to 0° and lock it
in place.
Step 5: Place a combination square’s head
on the miter table with its long flat side
against the table and its 45° side against
the blade body (not teeth).
Step 6: If the blade is not 45° to the miter
table, loosen the locking blot which are
located on the back of the saw (Fig. 22)
with small hex key (not supplied) and
carefully tilt the saw arm left or right until
the 45° side of the square is flush with the
saw blade along its entire length.
Step 7: Once the angle is set, retighten all
of the bolts and the bevel-lock lever.
(4) BEVEL-ANGLE INDICATOR
ADJUSTMENT
WARNING Failure to unplug your
saw could result in accidental starting
causing serious injury.
Step 1: Unplug the saw.
Step 2: Place the bevel angle at 0°
position, push down the bevel–lock lever to
lock it in place.
Step 3: Check to see if the bevel-angle
indicators of both sides are pointing to 0°
on the bevel scale (Fig. 23).
Step 4: If the indicator is not pointing to 0°,
loosen the bevel-angle indicator screw,
adjust the indicator to 0° on bevel-angle
scale,
Step 5: Retighten the bevel-angle indicator
screw.
FIG. 22
FIG. 23
ASSEMBLY AND ADJUSTMENT
