Page 16
3. Several cycles may be required to
lock the cutting head firmly.
SETTING THE BEVEL ANGLE
WARNING Before performing any
assembly or adjustment, always
disconnect from power source. Failure
to unplug your saw could result in
accidental starting causing serious
injury.
WARNING To avoid risk of personal
injury, if movement is tight or if there is
play in the bevel pivot, have your saw
serviced by an authorized service
center before using or contact (866)
902-9690 for assistance.
This saw has dual bevel and is equipped
with two sets of bevel scale to show the
bevel angle. If tilt the saw head to the left,
please read the right bevel scale, when
tilting the saw head to the right, please
read the left bevel scale.
The bevel angle of this equipment ranges
from left 47° to right 47° (Fig. 9).
This tool has a 0°, 33.9°, 45° left or right
detent feature to automatically hold it at
these bevel angles setting. There is an
angle detent pin on this tool for quick
adjustment.
To adjust the bevel angle without the
bevel angle detent pin being used.
Step 1: Unplug the saw.
Step 2: Lift the bevel lock lever to unlock the
saw cutting head. To avoid the saw head
tilting down suddenly due to its own weight,
hold the saw arm in place with one hand
when loosening the bevel-lock lever.
Step 3: Make sure the angle detent pin is in
disengaged position (Fig. 10). If not, pull the
pin out and rotate its cross pin 1/4 turn left
or right, release the pin to allow it to return
and rest in the disengaged position.
Step 4: Tilt the saw head to required bevel
left or right, push down the bevel lock lever
to lock the saw cutting head in place.
To adjust the bevel angle with the bevel
angle detent pin being used (Fig. 11).
Step 1: Unplug the saw.
Step 2: Lift the bevel lock lever to unlock the
saw cutting head. To avoid the saw head
tilting down suddenly due to its own weight,
hold the saw arm in place with one hand
when loosening the bevel-lock lever.
Step 3: Pull out the bevel angle detent pin
with one hand to allow the saw head to tilt
freely, holding the bevel angle detent pin in
this position.
Step 4: Tilt the saw head to the required
angle.
Step 5: Release the bevel angle detent pin
and keep moving the saw head until the
bevel angle detent pin engages into its
detent automatically (Fig. 11).
Step 6: Push down the bevel lock lever to
lock the saw head in place.
To lock the cutting head
To unlock the cutting head
FIG. 8
FIG. 9
FIG. 10
FIG. 11
ASSEMBLY AND ADJUSTMENT
