Page 25
NOTE: This tool has multi-slide bar
of two sections. Each section can be
locked/unlocked by the locking knob.
NOTE: When performing any bevel
cuts, the upper fence can slide left or
right depending on your requirement.
Step 1: Unplug the saw.
Step 2: Set the bevel angle at desired
angle and turn the miter table to 0° (refer
to ‘Setting the bevel angle’ section) (Fig.
29).
Step 3: Properly position the work piece.
Make sure that the work piece is clamped
firmly against the table and the fence.
Ensure the work piece clamp does not
interfere with the cutting operation.
Step 4: Carefully follow all instructions for
applicable chop cuts or slide cuts
according to your requirement.
Step 5: After finishing the cut, release
trigger and wait until the blade comes to a
complete stop before returning the saw
arm to the raised position.
Step 6: Remove the work piece and
repeat. When cutting a long work piece or
do repeated cutting, use extension table
and length stop.
COMPOUND MITER CUTS
Compound miter cuts are used for
decorative moldings, picture frames and
other fine joinery. To make this type of cut,
the miter table must be rotated to the
correct miter angle and the saw arm must
be tilted to the correct bevel angle.
Always take special care when making
compound miter cuts, due to the
interaction of the miter angle setting and
bevel angle setting, the first angle setting
should be checked after setting the second
angle, Once the two correct settings for a
particular cut have been obtained, always
make a test cut.
WARNING Never pull the saw toward
you during a cut. The blade can
suddenly climb up on top of the work
piece and force itself toward you.
WARNING Failure to unplug the saw
could result in accidental start up,
which may cause serious injury.
WARNING Use a clamping position
that does not interfere with the cutting
operation.
WARNING To avoid serious personal
injury, always tighten the bevel-lock
lever and miter-lock lever securely
before making a cut. Failure to do so
could cause serious injury.
NOTE: This tool has multi-slide bar
of two sections. Each section can be
locked /unlocked by its own locking
knob.
NOTE: When performing any
compound miter cuts, the upper fence
could be moved depending on your
requirement.
Step 1: Unplug the saw.
Step 2: Tilt the saw head to desired bevel
angle and turn the miter table to desired
angle (Fig. 30).
Step 3: Properly position the work piece.
Make sure that the work piece is clamped
firmly against the table and the fence.
Ensure the work piece clamp does not
interfere with the cutting operation.
Step 4: Carefully follow all instructions for
applicable chop cuts or slide cuts
according to your requirement.
Step 5: After finishing the cut, release
trigger and wait until the blade comes to a
complete stop before returning the saw
arm to the raised position.
Step 6: Remove the work piece and
repeat. When cutting a long work piece or
do repeated cutting, use extension table
and length stop.
FIG. 29
FIG. 30
OPERATION
