Maserati GranTurismo Sport 2015, Owner'S Manual

Page: 53 / 242

A
2
53
Eight-sensor system with Stop &
Go Function activated
When the Stop & Go function is
activated, all sensors are automatically
activated with the key set to
MAR
( ON ) but they are not displayed on the
instrument panel. When the vehicle
is put into reverse or an obstacle is
detected, the corresponding detection
areas are displayed on the instrument
panel. When the vehicle is put out of
reverse, all sensors remain active: the
rear sensors for approx. 10 seconds
or until the vehicle exceeds approx. 6
mph (10 km/h), and the front sensors
until the vehicles exceeds approx. 6
mph (10 km/h). At a speed of 6 mph
(10 km/h) or lower, the front sensor
detection areas are displayed as soon
as the system detects an obstacle and
the beeper sounds. If no obstacle is
detected for 10 seconds, the displayed
information disappears.
Front sensors can be temporarily
deactivated by pressing pushbutton
A : the system will sound a beep and
the pushbutton LED will turn off.
When pushbutton
A is pressed again,
the sounding of a beep and the LED
turned on will alert the driver that the
sensors are now active again.
Eight-sensor system with Stop &
Go function deactivated
With the Stop & Go function
deactivated by the Multi Media
System, the rear sensor activation/
deactivation operating logic remains
unchanged. For the front sensors, the
Stop & Go function signal status will
not change if pushbutton
A is pressed,
and the front sensors will be active
and displayed on the instrument
panel as long as vehicle speed is 6
mph (10 km/h) or lower. When the
vehicle goes over this speed but then
slows to 6 mph (10 km/h) or lower,
the sensors will not be activated. To
reactivate them, press pushbutton
A .
WARNING: Front sensors are activated
only when the LED on pushbutton
A is
on. In addition, the system will ignore
the pressing of pushbutton
A when
vehicle speed is over 6 mph (10 km/h).