Maserati GranTurismo Sport 2015, Owner'S Manual

Page: 151 / 242

5
151
Storing a speed
Turn switch A to ON reach the desired
speed driving normally. Turn the
rotating section
B to (+) for at least
three seconds and then release it.
The vehicle speed is stored and the
accelerator pedal can be released.
The vehicle will proceed at the
constant speed stored until the brake
pedal is pressed.
If necessary, (for example, to pass
another vehicle), you can accelerate
by simply pressing the accelerator
pedal. Afterwards, when you release
the accelerator pedal, the vehicle will
return to the speed previously stored.
Resuming the speed stored
If the device has been deactivated
after braking, the speed previously
stored can be resumed as follows:
- gradually accelerate until you reach
a speed close to that stored;
- engage the gear selected when
the speed was stored (4 th , 5 th or 6 th
gear);
- press button C ( RCL ).
Increasing the speed stored
The speed stored can be increased in
two ways:
- by pressing the accelerator and
then storing the new speed reached
(turn the rotating section
B for
more than three seconds)
or
- by turning the rotating section
B to
position (+): each pulse transmitted
by the rotating section will cause a
slight increase in speed (about 0.6
mph / 1 km/h), whereas a constant
pressure on the same rotating
section will cause a continuous
increase in speed. When the
rotating section
B is released, the
new speed will be automatically
stored in the memory.