MARUTI SUZUKI Ciaz, Owner'S Manual

Page: 86 / 249

3-14
OPERATING YOUR VEHICLE
79MH0-74E
57L21131
1) Make sure the parking brake is set fully.
2) Manual Transaxle – Shift to “N” (Neu-
tral) and fully depress the clutch pedal.
Hold the clutch and brake pedals fully
depressed.
Automatic transaxle – If the gearshift
lever is not in the “P” (Park) position,
shift it to “P”. Hold the brake pedal fully
depressed.
3) The “PUSH” indicator light in the instru-
ment cluster will come on. Press the
engine switch (1).
4) Within about 10 seconds of blinking of
the “PUSH” indicator light in the instru-
ment cluster, touch the engine switch
with the lock switch end of the remote
controller (2) for about 2 seconds.
NOTE:
• If you still cannot start the engine after
several attempts using the above
method, there may be a problem else-
where, such as a low battery. Contact
your MARUTI SUZUKI dealer for inspec-
tion.
• The immobilizer/keyless push start sys-
tem warning light come on for about 5
seconds while the “PUSH” indicator light
is blinking.
• You may customize the system to cause
the interior buzzer to sound once for the
“remote controller out of sensing range”
warning. Please contact an authorized
MARUTI SUZUKI dealer for the customi-
zation.
• If the battery of the remote controller is
about to be completely discharged, the
keyless push start system remote con-
troller battery consumption warning light
in the instrument cluster will come on for
a few seconds when the ignition mode is
changed to “ON” by pressing the engine
switch. For details on replacing the bat-
tery, refer to the “Keyless Push Start
System Remote Controller” in the
“BEFORE DRIVING” section.
Returning the ignition mode to
“LOCK” (OFF)
Automatic transaxle – To ensure safety, the
ignition mode can be returned to “LOCK”
(OFF) by pressing the engine switch only
when the gearshift lever is placed in the “P”
position without pressing the knob button.
NOTE:
In the case of an automatic transaxle
model, the engine cannot be returned to
the “LOCK” (OFF) position if the gearshift
lever is in any other position than “P”.
Certain problems like a fault in engine sys-
tem may prevent the engine switch from
going back to the “LOCK” (OFF) mode. If
this happens, have the vehicle inspected
by an authorized MARUTI SUZUKI dealer
after doing the following:
• Lock the doors using the key to prevent
theft. (The request switches and the key-
less push start system remote controller
cannot be used to lock them.)
• Disconnect the negative cable from the
battery to prevent discharge.
“LOCK” (OFF) mode reminder buzzer
If the driver’s door is opened without
returning the ignition mode to “LOCK”
(OFF) by pressing the engine switch, a
buzzer sounds to warn you of this state.
• If you open the driver’s door after press-
ing the engine switch to change the igni-
tion mode to “ACC”, the interior buzzer
beeps intermittently.
(1)
(2)
EXAMPLE