MARUTI SUZUKI Ciaz, Owner'S Manual

Page: 31 / 249

2-14
BEFORE DRIVING
79MH0-74E
How to stop the alarm
Should the alarm be triggered accidentally,
the alarm will stop by the following opera-
tions.
• Press the engine switch to change the
ignition mode to “ON” or turn the ignition
switch to “ON” position.
• Unlock the doors using the keyless push
start system remote controller, the
request switch, or the keyless entry sys-
tem transmitter.
NOTE:
• Even after the alarm has stopped, if you
lock the doors using the keyless entry
system transmitter or keyless push start
system remote controller, the security
system will be rearmed with a delay of
about 5 seconds.
• If you disconnect the battery while the
security system is in the armed condition
or the alarm is actually in operation, the
alarm will be re-triggered when the bat-
tery is then reconnected.
• Even after the alarm has stopped at the
end of the predetermined operation time,
it will be triggered again if any of the
doors, trunk or engine hood is opened,
or the vehicle feels a shock (if the shock
sensor is in the enabled state), without
disarming the security system.
Checking whether the alarm has been
triggered during parking
If the alarm was triggered and you then
turn the ignition switch to “ON” position or
the ignition mode is “ON”, the security sys-
tem indicator will blink rapidly for about 8
seconds and a buzzer will beep 4 times
during this period. If this happens, check
whether the vehicle has been broken into
while you were away from it.
Enabling and disabling the security
system
The security system can be either enabled
or disabled.
When enabled
• If any of the doors or trunk are opened
without unlocking by the keyless entry
system transmitter or keyless push start
system remote controller, all turn signal
lights start to blink and the interior
buzzer beeps intermittently. After 5 sec-
onds, the siren will sound for about 27.5
seconds. The security system indicator
continues to blink during this time.
• If the engine hood is opened, all turn sig-
nal lights blink, and the siren sounds for
about 27.5 seconds. The security sys-
tem indicator continues to blink during
this time.
(If the shock sensor is in the enabled state)
• If the vehicle feels a shock higher than
the pre-warning sensitivity, the siren
sounds for about 2 seconds (pre-warn-
ing). If the vehicle feel a shock higher
than the full blast warning sensitivity, all
turn signal lights start to blink and the
interior buzzer beeps intermittently. After
5 seconds, the siren will sound for about
27.5 seconds (full blast warning). The
security system indicator continues to
blink during this time.
NOTE:
If you set the full blast warning sensitivity
higher than the pre-warning sensitivity in
the setting mode of the information display,
or the vehicle feels such shock as to be
able to trigger the full blast warning, the full
blast warning will be triggered preferen-
tially. In this case, the pre-warning will not
be triggered.
When disabled
When the system is disabled, it stays dis-
armed even if you perform any system
arming operation.
How to switch the state of the security
system
When the security system has been
already disarmed, you can switch the sys-
tem from the enabled state to the disabled
state, and vice versa, using the following
method.