MARUTI SUZUKI Ciaz, Owner'S Manual

Page: 115 / 249

5-2
OTHER CONTROLS AND EQUIPMENT
79MH0-74E
Engine Hood
79MH0502
To open the engine hood:
1) Pull the hood release handle located on
the outboard side of the driver’s side of
the instrument panel. This will disen-
gage the engine hood lock halfway.
79MH0503
2) Push the under-hood release lever
sideways with your finger, as shown in
the illustration. While pushing the lever,
lift up the engine hood.
79MH0540
3) While holding the hood, pull the prop
rod out from the holding clip, then insert
the end of the rod into the designated
hole.
To close the engine hood:
1) Lift the hood up slightly and remove the
prop rod from the hole. Put the prop rod
back to the holding clip.
79MHA0501
2) Lower the hood to about 20 cm above
the hood latch, then let it drop down.
Make sure the hood is securely latched
after closing.
EXAMPLE
EXAMPLE
CAUTION
The release lever can be hot enough
to burn your finger right after driving.
Touch the lever after it becomes cool
enough.
NOTICE
Make sure that the wiper arms are not
raised before you lift up the engine
hood to avoid damaging the wiper
arms and the engine hood.
EXAMPLE
CAUTION
• The prop rod can be hot enough to
burn your finger right after driving.
Touch the rod after it becomes cool
enough.
• Insert the end of the rod into the hole
securely. If the rod drops off, your
body may be caught in the hood.
• The rod may drop off when the
hood is hit by a wind. Be careful on
windy days.
EXAMPLE