MARUTI SUZUKI Ciaz, Owner'S Manual

Page: 61 / 249

2-44
BEFORE DRIVING
79MH0-74E
Security system “ ”
• : Enable the security system
(default setting)
• : Disable the security system
Shock sensor “ ”
• : Enable the shock sensor
• : Disable the shock sensor
(default setting)
Pre-warning sensitivity of
the shock sensor “
”
• : Disable the pre-warning
• to :
Adjust the pre-warning sensi-
tivity of shock sensor (Lowest
sensitivity level is L01 and
highest is L15, and default
setting is L14)
Full blast warning sensitivity
of the shock sensor “
”
• : Disable the full blast warning
• to :
Adjust the full blast warning
sensitivity of shock sensor
(Lowest sensitivity level is L01
and highest is L15, and
default setting is L09)
Initialization setting “ ”
• : Initialize all settings
76MH0017
NOTE:
• As shown in the above illustration,
“ ” indicates on the display of cur-
rently setting item.
• To go back to the higher level display
during operation, turn the indicator
selector knob (3) to display “
” or
“ ” and then push the indicator
selector knob (3).
• If the security system “ ” is in the dis-
abled state, the shock sensor “ ”, pre-
warning sensitivity “ ” and full blast
warning sensitivity “ ” cannot be set
up.
5) To exit the setting mode, switch the dis-
play to show “ ” and then push the
indicator selector knob (3).
Warning and Indicator Lights
Brake System Warning Light
65D477
For working check of this light, there are
following three different type of operations
depending on the vehicle's specification.
1) The light comes on briefly when the
ignition switch is turned to the “ON”
position or the engine switch is pressed
to change the ignition mode to “ON”.
2) The light comes on when the parking
brake is engaged with the ignition
switch in the “ON” position or the igni-
tion mode “ON”.
3) The light comes on when under either
or both of above two conditions.
The light also comes on when the fluid in
the brake fluid reservoir falls below the
specified level.
EXAMPLE