Martin VDO Face 5, User Manual

Page: 37 / 56

Physical installation 37
3. Line up the angle markings D on the upper plate of the second header with the alignment line E on the
lower plate of the first header to set the two Curving Headers at a 5° or 10° angle to each other. To install
panels in a straight line, set the Curving Headers at a 0° angle.
4. Tighten the clamp screw B by hand and tighten the pivot screw A with an Allen key (hex wrench). Do not
overtighten – the curving alignment plates (see next section) will provide the necessary rigidity in the
array.
Curving Alignment Plates
When you create a curved array,
you must secure panels with VDO
Face Curving Alignment Plates
instead of the corner connection
plates shown in Figure 22 on page
25.
See Figure 34. VDO Face Curving
Alignment Plates are available in
two versions:
• Part Number 91616084 lets you
suspend panels in a concave or
convex 5° curve.
• Part Number 91616085 lets you
suspend panels in a concave or
convex 10° curve.
Figure 33: VDO Face Curving Header
A
B
C
D
E
D
Figure 34: Curving Alignment Plates
5 degree curving plate, P/N 91616084
10 degree curving plate, P/N 91616085