Setup
65
Setting a Luminaire to
Remote Control
mode
Before you can set up or program a Luminaire with the remote control,
you must set the Luminaire to
Remote Control
mode to allow
communication between the two devices:
1. See Figure 36.
Point the remote
control at the IR
sensor on the back
of the Luminaire.
2. See Figure 35.
Hold the
PP
key
pressed in for five
seconds. When
communication is
established, the
status indicator
LED incorporated
in the sensor
begins to flash
green and the
Luminaire gives
three slow flashes
(yellow in RGBW
Luminaires).
3. See Figure 37.
Note the last four
digits of the
Luminaire’s serial
number labeled on
the fixture and
enter them using
the numeric
keypad on the
remote control.
The Luminaire
should flash each
time you press a
button.
4. Press the
Sign
key.
• If the four digits
have been entered correctly, the Luminaire flashes (green in RGBW
Luminaires) three times slowly to show that it has entered
Remote
Figure 36: IR sensor and status indicator
LED
Figure 37: Luminaire serial number