Martin Professional Wizard Extreme, User Manual

Page: 11 / 43

Installation 11
I
NSTALLATION
The Wizard Extreme can be hung overhead with a clamp (not included),
mounted vertically on a wall, or placed on the floor (using the optional
floor stand).
Warning! Block access below the work area before proceeding. Always
use a secure means of secondary attachment.
W A L L M O U N T I N G
To mount the Wizard Extreme on a wall, or other vertical surface:
1. Verify that the surface is capable of bearing the weight of the fixture.
2. Set two 8mm-diameter hex bolts or screws, 155 mm (6.1 in.) apart
(center to center), in the mounting surface.
3. Set an eyebolt in the mounting surface
for the safety cable.
4. Fold the mounting bracket so that it lies
flat against the back of the fixture and
t i g h t e n t h e s w i v e l l o c k s . We
recommend that you remove the swivel
lo c k s a n d r e pl a c e t h e m w i t h M 8
hexagonal lock nuts (these can be
supplied by your Martin dealer: 2 x P/N
08132701); alternatively set the swivel
locks so that they lie flat against the
fixture.
5. Hang the fixture on the wall over the two screw/bolt heads using the
two slotted holes in the mounting bracket.
6. Install a safety cable that can hold at least 10 times the weight of the
fixture through the safety cable eye on the fixture and attach this to the
eyebolt.
7. Verify that the fixture is at least 0.1 meters (4 in.) from the surface to
be illuminated and at least 0.3 meters (12 in.) from any combustible
materials. Verify that the clearance around the air vents is at least 0.1
meters (4 in.).
max 13mm
/ ½"
Ø8mm