![background image](http://html1.mh-extra.com/html/mars/comfort-aire-rxts-series/comfort-aire-rxts-series_installation-and-operation-manual_1730540027.webp)
IOM -
RXTS Series
27
WALL-MOUNTED INSTRUCTIONS
CAUTION
All side louvers of the cabinet must remain
exposed to the outside of the structure.
Suggested tools
Select the best location
Select the best location
1 . Screw driver (medium size Phillips)
2. Tape measure or ruler
3. Knife or scissors
4. Level gaug
1. To avoid vibration and noise, make sure the
unit is installed securely and firmly.
2. Install the unit where the sunlight does not
shine directly on the unit. If the unit receives
direct sunlight, build an awning to shade the
cabinet.
3. There should be no obstacle, such as a fence or
wall, within 50cm from the back of the cabinet
because it will prevent heat radiation of the
condenser. Restriction of outside air will greatly
reduce the cooling and heating efficiency of the
air conditioner.
4. Install the unit a little obliquely outward not to
leak the condensed water into the room (about
3~4 Owith level).
5. Install the unit with its bottom portion 75~150cm
above the floor level.
6. The power cord must be connected to an
independent circuit. The yellow/green wire
must be grounded.
Installations of the unit into the wall
OPTION A
OPTION B
Note:
After installing, make sure the air conditioner
is tilted 3~4
°
to the outside to allow water drainage
and perfect cooling efficiency.
AIR IN
AIR IN
AIR OUT
100mm minimum
AIR IN
LOUVRE
BRICK
WALL
O
45 BRICK CUT AWAY
TO CLEAR LOUVRES
FRONT
AIR OUT
AIR IN
AIR IN
TOP
VIEW
O
45 BRICK CUT AWAY
TO CLEAR LOUVRES
100mm
BRICK
WALL
100mm
75~150cm
Over 50cm
AWNING
FENCE
O
3~4
Note: Unit may be supported by a solid frame from
below or by a hanger from a solid overhead support.
Note:
Remove the air conditioner and hardwares
from the carton and place on a flat surface.
Save Carton and these Installation Instructions
for future reference. The carton is the best way
to store unit during winter, or when not in use.
Hardware(Packed with the unit)
Sealed sponge
Weather stripping
(10*3/4” *1/12”)
2
1
1
1set
1
Window sash seal foam
1
Open Window Bracket – LH1
Owner’s Manual
Open Window Bracket – RH
Page 27
Installation
Instructions