![background image](http://html1.mh-extra.com/html/mars/comfort-aire-rxts-series/comfort-aire-rxts-series_installation-and-operation-manual_1730540006.webp)
IOM -
RXTS Series
6
Important Safety
Instructions
WARNING
Do not, under any
circumstances, cut,
remove, or bypass
the grounding prongs.
NOTICE:
The power supply cord with this air conditioner contains a current detection device
designed to reduce the risk of fire. Please refer to the section Operation of Current Device
for details. In the event that the power cord is damaged, it cannot be repaired – it must be
replaced with a cord from the product manufacturer.
Avoid fire hazard or electric shock. Do not
use an extension cord or an adapter plug.
Do not remove any prongs from the power
cord.
Grounding type wall receptacle
Power supply cord with
3-prong grounding plug
and current detection
device.
DANGER
Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other
appliance.
For Your Safety
DANGER
WARNING
The complete electrical rating of your new room air conditioner is stated on the serial plate. Refer to
the rating when checking the electrical requirements.
Be sure the air conditioner is properly grounded. To minimize shock and fire hazards, proper
grounding is important. The power cord is equipped with a three-prong grounding plug for
protection against shock hazards.
Your air conditioner must be used in a properly grounded wall receptacle. If the wall receptacle you
intend to use is not adequately grounded or protected by a time delay fuse or circuit breaker, have a
qualified electrician install the proper receptacle. Ensure the receptacle is accessible after the unit
installation.
Do not run air conditioner without side protective cover in place.This could result in mechanical
damage within the air conditioner.
Do not use an extension cord or an adapter plug.
Electrical Information
Important Safety
Instructions
Page 6
To reduce the risk of fire, electrical shock, or injury when using your air conditioner, follow basic
precautions, including the following:
Be sure the electrical service is adequate for the model you have chosen. This information can be
found on the serial plate, which is located on the side of the the cabinet and behind the grille.
It is recommended to clean both sides of the window glass first. If the window has a screen panel
included on the lower portion, the screen panel should be removed before installation.
Be sure the air conditioner has been securely and correctly installed according to the installation
instructions in this manual. Save this manual for possible future use in removing or installing this unit.
When handling the air conditioner, be careful to avoid cuts from the sharp metal fins on the front and
rear coils.
Prevent Accidents