MARKEM Cimjet RFID, Operation & Service Manual

Page: 87 / 158

SECTION 5 Operating Modes
0855904enb 4/05
m
®
5–1
1.0 Operating Modes
The Cimjet RFID can be fitted with various applicator modules to
suit specific applications. The application may require that tags be
applied to the top, front, side, front and side or top and side of the
product packs.
The type of application required and the number of packs/minute will
determine which style of applicator is best suited for the job.
In most cases, the Apply sequence is triggered by a sensor
mounted on the transport conveyor.
In some special applications, the Apply sensor may be dispensed
with and the required functions performed using a serial
communications link.
Three factors determine the position of the tag on the pack:
• The position of the applicator relative to the conveyor
• The position of the sensor
• The setting of the Apply Delay timer
Any one of these factors can affect the position of the tag placement
in the direction of the product motion.
A suitable combination of these factors must be determined.
Note: The machine should, in most cases, be mounted square to
the products.
2.0 Application Cycle
Three options are normally available, depending on the applicator
being used:
Auto Apply : Feed sensor only
Pre-feed : Apply sensor only
On Demand : Feed sensor and Apply sensor
Note: Feed and Apply sensors will only be operational when the
Run Mode is implemented, and the dispenser positions the
applicator to its Home position.