MARKEM Cimjet RFID, Operation & Service Manual

Page: 49 / 158

SECTION 2 Installation Guide
0855904enb 4/05
m
®
2–3
3.0 Air Requirements
A compressed air supply is normally required by the Cimjet RFID to
drive the applicator module. This must be set to 6.2 Bar (90psi) with
a minimum flow rate of 4cfm (cubic feet per minute) (113 liters/
minute) and should be dry, uncontaminated air which should not be
lubricated.
3.1 Air Regulator
A filter regulator assembly is fitted to the base of the stand; this is
comprised of a manual isolation valve, a water trap and pressure
regulator. The air supply is via a 6mm or 8mm flexible pipe.
A single connection is supplied to the main filter regulator unit; from
here, the regulated supply goes to the applicator (if air operated)
and the unregulated supply goes to the air input on the dispenser.
to dispenser
to applicator