MARKEM Cimjet RFID, Operation & Service Manual, Page: 50 / 158

SECTION 2 Installation Guide
2–4
m
®
0855904enb 4/05
4.0 I/O Interface
Connections for all sensors and solenoids are accessed by
removing the rear cover. External I/O is connected via the External
I/O connector (25-way D-type connector (X12)) located on the rear
of the Cimjet RFID.
For full details, see Section 7– Technical Information .
5.0 Positioning the Applicator
The Cimjet RFID is normally supplied with a stand which allows the
positioned tag height on the product to be adjusted within a limited
range. The applicator height will be determined by the conveyor
height and required position of the tag on the product.
Leveling feet are not provided as standard, so care should be taken
to align the machine with the product transportation system.
Before final positioning, the machine should be placed so that the
applicator arm is square to the product and the position of the
machine provides the correct tag position on the product.
CAUTION: If the machine is not secured to the floor, it is
possible for the machine to gradually change
position during use. It is, therefore, important to
mark the provisional position of the machine prior
to starting tagging trials.
Installation drawings are available which show the range over which
the Cimjet RFID can apply tags. Refer to the previous pages in this
section and also to
Section 10 – Illustrations and Schematics .
For more applicator information, refer to the Cimjet RFID Blow
Applicator Manual (0855906) and the Cimjet RFID Tamp
Applicator Manual (0855907).