MARKEM Cimjet RFID, Operation & Service Manual

Page: 47 / 158

SECTION 2 Installation Guide
0855904enb 4/05
m
®
2–1
1.0 Installation of the Cimjet RFID
Installation should only be performed by qualified and trained
personnel; customer installation should be sanctioned by MARKEM.
WARNING: Failure to perform installation as stated above will
invalidate the machine warranty.
1.1 Installation Requirements
Ensure that the required services and control signals are available:
• Power: 110-240V single phase power supply rated at 300VA
continuous (750VA maximum at switch on)
• Compressed air: a dry, clean, non-lubricated air supply at 6.2
Bar (90psi)
• Trigger signals depending on the application
• Sufficient space for installation and operation
WARNING: All applicator cylinders have been factory-set to
1.86 Bar for safety. If the cylinders are operated
over 1.86 Bar, the machine must be protected by
guarding, supplied by the customer.
SAFETY: Do not adjust the applicator regulator pressure
above 1.86 Bar under any circumstances. Doing so
could make the Cimjet RFID unsafe.
CAUTION: It is essential that the connector dust covers
provided with the machine are fitted to all unused
connectors to protect against dust and dirt and
prevent possible static damage to internal
components.