MARKEM Cimjet RFID, Operation & Service Manual, Page: 137 / 158

SECTION 7 Technical Information
0855904enb 4/05
m
®
7–29
9.0 Pneumatics
9.1 Air Requirements
A compressed air supply is required by the Cimjet RFID to drive the
applicator module. This must be air at 6 Bar and should be:
dry,
uncontaminated air, and not lubricated .
A filter regulator assembly is fitted to the base of the stand; this is
comprised of a manual isolation valve, a water trap, pressure
regulator, and dump valve. The air supply is via a 6mm or 8mm
flexible pipe.
9.2 Compressed Air Requirements
WARNING: Do not adjust the regulator pressure under any
circumstances. Doing so could make the Cimjet
RFID unsafe.
A filter regulator is provided as standard and includes:
• Isolation value (non-lockable)
• Pressure regulator
• Pressure indication dial (0-10 bar)
• Filter (micro mesh)
• Water trap
The unregulated supply goes to the Cimjet RFID dispenser .
The regulated supply goes to the applicator .