Steel cable tightening up
After positioning the steel cable tight it up in order to make a proper sliding of the covering possible.
As a matter of fact the Left and Right front supports have been developed and manufactured with the aim to allow the
operator steel cable tension adjustments.
Operating alternately on the two supports, proceed as follows:
•
Use a 7 Nm torque wrench to tighten the screw placed on the front side (
1
) of the LH support.
As a consequence the pulley (
2
) moves backwards tightening up the steel cable.
•
Act alternatively on one support and on the other one, tightening up the cable in the same way on both sides;
When the required tension is achieved block the guide pulley tightening the central screw (
3
).
WARNING!
During installation of the metal cable, it is strictly mandatory to wear gloves in order to prevent hand
injuring caused by the possible fraying of the metal mesh.
IMPORTANT!
Once terminated this operation
make sure that the bow is perpendicular to the side board and at
equal distance from the tailgate
. If not, operate consequently on the tensioning device of the steel
cable or, if necessary, proceed to block it.
