NAMES AND
FUNCTIONS
8
BASIC
CONNECTIONS
BASIC
OPERA
TION
ADV
ANCED
CONNECTIONS
SETUP
ADV
ANCED
OPERA
TION
TROUBLESHOOTING
OTHERS
BASIC
CONNECTIONS
BASIC CONNECTIONS
SPEAKER PLACEMENT
The ideal surround speaker system for this unit is 5-speaker systems, using front left and right speakers, a
center speaker, surround left and right speakers and a subwoofer.
For best results we recommend that all front speakers be of the same type, with identical or similar driver
units. This will deliver smooth pans across the front sound stage as the action moves from side to side.
Your center channel speaker is very important as over 80% of the dialog from a typical motion picture
emanates from the center channel.
It should possess similar sonic characteristics to the main speakers. Surround channel speakers need not be
identical to the front channel speakers, but they should be of high quality.
One of the benefi ts of both Dolby Digital and DTS is that surround channels are discrete full range, while they
were frequency limited in earlier “Pro Logic’ type systems.
Bass effects are an important part of home theater. For optimal enjoyment a subwoofer should be used as
it is optimized for low frequency reproduction. If you have full range front speakers, however, they may be
used in place of a subwoofer with proper setting of the switches in the menu system.
Front Right
Front Left
Front
Center
Surround
Left
Surround
Right
Subwoofer
FRONT LEFT AND RIGHT SPEAKERS
We recommend to set the front L and R speakers
with 45-60 degrees from the listening position.
CENTER SPEAKER
Align the front line of the center speaker with the
front L/R speakers. Or place the center speaker a
little backward from the line.
SURROUND LEFT AND RIGHT SPEAKERS
When this unit is used in surround operation, the
preferred location for surround speakers is on the
side walls of the room, at or slightly behind the
listening position.
The center of the center speaker should face the
center of the room.
SUBWOOFER
We recommend using a sub-woofer to have maximum
bass effect. As the subwoofer only handles low
frequencies, you can place it any where in the room.
HEIGHT OF THE SPEAKER UNITS
FRONT LEFT AND RIGHT SPEAKERS,
AND A CENTER SPEAKER
Align the tweeters and mid-range drivers on the
three front speakers at the same height, as best
as possible.
Note
Use magnetically-shielded speakers for front left,
right and the center speakers when the speakers are
installed near the TV.
SURROUND LEFT AND RIGHT SPEAKERS
Place the surround left, right higher than your ears
by about 70cm – 1m. Also place the speakers at the
same height, as best as possible.
70cm
1m
CONNECTING SPEAKERS
• Be sure to use speakers with the specifi ed impedance as shown on the rear panel of this unit.
• When the subwoofer you are connecting is a powered subwoofer (i.e., has a built-in amp), connect it to
the PRE OUT subwoofer jack.
MODEL NO. SR3053
MODEL NO. SR3053
AC IN
AC IN
FM
FM(
(75
75
Ω
Ω
)
)
GND
GND
AM
AM
ANTENNA
ANTENNA
DVD
DVD
L
L
SL
SL
C
C
R
R
L
L
R
R
L
L
SUB
SUB
WOOFER
WOOFER
R
R
SR
SR
5.1CH INPUT
5.1CH INPUT
PRE OUT
PRE OUT
SW
SW
SURROUND
SURROUND
FRONT
FRONT
MONITOR OUT
MONITOR OUT
BLU-RAY
BLU-RAY
VIDEO
VIDEO
OUT
OUT
IN
IN
L
L
R
R
Y
Y
VCR
VCR
OUT
OUT
DVD
DVD
IN
IN
BLU-RAY
BLU-RAY
VCR
VCR
DVD
DVD
BLU-RAY
BLU-RAY
IN
IN
MONITOR
MONITOR
OUT
OUT
IN
IN
DVD
DVD
BLU-RAY
BLU-RAY
OUT
OUT
REMOTE
REMOTE
CONTROL
CONTROL
ANALOG AUDIO
ANALOG AUDIO
DIGITAL AUDIO IN
DIGITAL AUDIO IN
IN
IN
COMPONENT VIDEO
COMPONENT VIDEO
MONITOR
MONITOR
OUT
OUT
P
P
B
B
C
C
B
B
P
P
R
R
C
C
R
R
SPEAKER SYSTEMS : 6-8 OHMS
SPEAKER SYSTEMS : 6-8 OHMS
CENTER
CENTER
BLU-RAY
BLU-RAY
CD
CD
COAXIAL
COAXIAL
OPTICAL
OPTICAL
DVD
DVD
CD
CD // TAPE
TAPE
R
R
L
L
R
R
L
L
SUB
SUB
WOOFER
WOOFER
PRE OUT
PRE OUT
SURROUND
SURROUND
FRONT
FRONT
SPEAKER SYSTEMS : 6-8 OHMS
SPEAKER SYSTEMS : 6-8 OHMS
CENTER
CENTER
Right
Left
Right
Left
Surround
Front
Center
Powered
subwoofer
Note
• To prevent damage to circuitry, do not let the bare speaker wires touch each other and do not let them touch any
metal part of this unit.
• Do not touch the speaker terminals when the power is on. It may cause you to receive an electric shocks.
• Do not connect more than one speaker cable to one speaker terminal. Doing so may damage this unit.
• Be sure to connect the positive and negative cables for the speaker properly. If they are miss-connected, the
signal phase will be reversed and the signal quality will be corrupted.
SR3053̲S̲01̲ENG.indd 8
SR3053̲S̲01̲ENG.indd 8
09.4.21 11:46:51 AM
09.4.21 11:46:51 AM
