Rotate “PM2” encoder to edit the IP value. By using “PM3” encoder can change the IP address for
this unit.
NOTE:
Only when DHCP is off can user set the IP address of the unit. If DHCP is ON, need to push
the “ENTER” button until the unit notify that the DHCP is activated, that the IP address of LPP-
360A need to capture from the router in its connected network.
2. Set the connection condition of PC (take XP for example)
Enter the PC’s “controlling Pannel’
”network connect”
”local”, open the dialogue box of
“ Properties”, please refer to the following picture:
Select “Internet Protocol (TCP/IP” in “
use the following subjects under this connection(0)
”, and
click the attribute bottom, marked in the red envelop in below image:
Open the dialogue box of “Internet aggreement (TCP/IP) attribute” and set as the following Fig 1,
Summary of Contents for LPP-360A
Page 39: ......
